Load And Test Cycle Function Numbers Chart - Whirlpool Cabrio WTW8500DW Technical Education

Load and Test Cycle Function Numbers Chart

NOTE: Some loads will not be available on all models
Display Function
000 Toggle Lid Lock
001 Toggle Cold Valve
002 Toggle Hot Valve
003 Toggle Fresh Fill Valve
004 Toggle Detergent Valve
005 Toggle Fabric Softener Valve
006 Toggle Oxi Valve
007 Toggle Bleach Valve
008 Toggle Drain Pump
009 Toggle Recirc. Pump
010 Toggle Low Speed Spin
011 Toggle Mid Speed Spin
012 Toggle High Speed Spin
013 Toggle Slow Agitate
014 Toggle Fast Agitate
015 Toggle Shifter
016 Toggle Basket Light
017 Toggle Heater
050 Run Factory Calibration
051 Service Diagnostics
052 Run Service Calibration
053 Run Dry Factory Calibration
075 Set Life Test Mode
For Service Technician Use Only
Notes
Note: To lock or unlock the lid, all loads (pumps, motor, valves, and
heater) must be off and the lid must be closed.
N/A
N/A
For water to flow, cold water should be turned on first. Note: If the fabric
softener valve is turned "ON" without the cold water valve "ON", water
can overflow the front of the tray.
For water to flow, hot water should be turned on first. Note: If the
Oxi valve is turned "ON" without the hot water valve "ON", water can
overflow the front of the tray. Note: Oxi not available on all models.
Note: On models with dump bleach dispenser, toggling this load will turn
on the Oxi valve.
Note: Not available on all models.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled. Note: The basket
must be empty for this function.
Switch in and out of Spin. Shifter On = Spin and Shifter Off = Agitate.
Note: This can only be commanded while the motor is not running. The
shifter will also be on when spin functions 10–12 are active.
N/A
Note: To actuate the heater, all loads (pumps, motor, and valves) must be
off and water level must be above the impeller.
Note: For factory test only.
Service Diagnostics for repair verification and installation
verification.
This calibrates the main control to the washer for optimal load size
sensing. Upon completion, the UI will display 000. The Soil Level and
Temp buttons can be used to review step results if Pass/Fail criteria exist.
If a step has no Pass/Fail criteria, --- will be displayed.
Note: For factory test only.
Note: For factory test only. If life test mode is accidentally activated, Life
Test can be exited by removing power from the washer and waiting for
the control to power down as indicated by the diagnostic LED ceasing to
flash (5-3).
DIAGNOSTICS & TROUBLESHOOTING
Whirlpool 2014 CABRIO Direct Drive Washer
®
5-5
n