Whirlpool Cabrio WTW8500DW Technical Education page 57

Service Diagnostic Chart (continued)
Display
014 Drain pump and
recirculation pump† on
for 25-30 seconds
015 Pause
016 Agitate for 5 seconds
017 Low speed spin for 5
seconds
018 Spin for 20-30 seconds
019 Agitate for 10 seconds
020 Unlock lid
†On models without recirculation pump, only the drain pump will turn on in step 14.
Service Diagnostics Pass/Fail Indication
After the cycle completes, the Pass or Failure status of each
step in Service Diagnostics is available by the following
procedures:
Models without a cycle selection knob
Press the soil level or temp buttons. The sequence step
increments using the soil level button and decrements using
the temp button.
Models with a cycle selection knob
In addition to pressing the soil level or temp uttons, rotating
the cycle selection knob clockwise increments through the
cycle functions while rotating counterclockwise decrements
through the available options.
On all models, the display will flash between the sequence
function number and "PAS" for Pass, "FAL" for Fail, or "---" if
the machine control is not capable of determining if a function
passed or failed; each will be displayed for 1 second.
For Service Technician Use Only
Washer
Function
If water is not being drained or recirculated,
use service test load controls to test the
drain pump.
N/A
Use service test load control to manually test
the motor.
Use service test load control to manually test
the motor.
Use service test load control to manually test
the motor.
Use service test load control to manually test
the motor.
If lid does not unlock, use service test load
control to manually test the lid lock.
Total time in minutes
DIAGNOSTICS & TROUBLESHOOTING
Recommended
Procedure
Exiting Service Diagnostics Mode
Press the POWER button. All loads will be turned off and the
washer will enter standby.
Fault Detection During Service Diagnostics
Execution
Some faults will stop the cycle execution (see Fault And Error
Codes charts on pages 5-9 to 5-11 for those faults [marked
with ‡] that stop the washer). If a fault is detected, the washer
will stop executing the cycle and the step during which the
fault was encountered will remain on the display. If no action
is taken within 5–10 minutes, the display will be cleared and
the washer will enter standby mode.
Whirlpool 2014 CABRIO
Est. Time
in Seconds
<10
5
5
5
30-40
10
5
Appx. 3-4 mins.
Direct Drive Washer
®
5-7
n