Load And Test Cycle Function Numbers Chart - Whirlpool WTW9500E SERIES Service Manual

DIAGNOSTICS & TROUBLESHOOTING

Load and Test Cycle Function Numbers Chart

NOTE: Some functions will not be available on all models
Display Function
000 Toggle Lid Lock
001 Toggle Cold Valve
002 Toggle Hot Valve
003 Toggle Fresh Fill Valve
004 Toggle Detergent Valve
005 Toggle Fabric Softener Valve
006 Toggle Oxi Valve
007 Toggle Bleach Valve
008 Toggle Drain Pump
009 Toggle Recirc. Pump
010 Toggle Low Speed Spin
011 Toggle Mid Speed Spin
012 Toggle High Speed Spin
013 Toggle Slow Agitate
014 Toggle Fast Agitate
016 Toggle Basket Light
017 Toggle Heater
018 Toggle Bulk Dispense Pump
050 Run Factory Calibration
051 Service Diagnostics
Verification Cycle
(see Chart on page 2-5)
052 Run Load Size Calibration
Cycle
053 Run Dry Factory Calibration
075 Set Life Test Mode
2-4 Whirlpool & Maytag Direct Drive Top Load Washer
n
For Service Technician Use Only
Notes
Note: To lock or unlock the lid, all loads (pumps, motor, valves, and
heater) must be off and the lid must be closed.
For water flow, the cold and/or hot water valve(s) should be turned on
first.
For water flow, the cold and/or hot water valve(s) should be turned on
first.
For water flow, the hot water valve should be turned on first.
For water flow, the hot water valve should be turned on first.
For water flow, the hot water valve should be turned on first.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled.
Note: The basket must be empty for this function.
Lid must be closed and locked for this to be enabled. Note: The basket
must be empty for this function.
Note: Basket light not available on all models.
Note: To actuate the heater, all functions (pumps, motor, and valves)
must be off and water level must be above the impeller. Not available on
all models.
Fill the bulk dispense pump with detergent. Look at the detergent cup for
flow, which will appear as a trickle after 11/2–2 minutes.
Note: For factory test only.
Service Diagnostics for repair verification and installation verification.
Upon completion, the UI will display 000. The Soil Level and Temperature
buttons can be used to review step results if Pass/ Fail criteria exist. If a
step has no Pass/Fail criteria, --- will be displayed.
This calibrates the main control to the washer for optimal load size
sensing. NOTE: Upon completion, the UI will display 000.
Note: For factory test only.
Note: For factory test only. If life test mode is accidentally activated, Life
Test can be exited by removing power from the washer and waiting for
the control to power down as indicated by the diagnostic LED ceasing to
flash (5-3).