Removing The User Interface (Ui) - Whirlpool Cabrio WTW8500DW Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Removing the User Interface
1. Unplug washer or disconnect power.
2. Perform the procedures on pages 4-3 or 4-4, "Removing
the Console" prior to performing the following steps.
3. Disconnect the 3-wire harness from the User Interface
(see Figure 1).
3-Wire Harness

Removing the User Interface (UI)

Figure 1
4. Remove the seven (7) 1/4" hex-head screws securing the
User Interface to the console (see Figure 2).
5. Using a flat blade screwdriver, gently, depress the six
plastic mounting clips to release the User Interface from
the console (see Figure 2).
6. User Interface should separate and lift away from console.
REASSEMBLY NOTE: When reinstalling the User Interface to
the console, only hand tighten the seven (7) hex-head screws
until snug. Using a power driver will strip the screw holes and
stress the capacitive touch user interface.
Plastic Mounting Clips
Figure 2
Whirlpool 2014 CABRIO
COMPONENT ACCESS
Direct Drive Washer
®
4-5
n