Using The Built-In Electronic Keyer - Yaesu FTDX101D Operation Manual

Using the Built-in Electronic Keyer

1.
2. Press the [CW] key to engage CW operation.
3. Rotate the Main Tuning Dial knob to select
the desired operating frequency.
4. Press the [BK-IN] key.
5. Press the [MONI] key.
The LED inside the [MONI] key glows orange; and the
CW monitor is activated.
6.
the builtin Electronic Keyer is now active.
7. Rotate the [MIC/SPEED] knob to set the de-
wise rotation of the [MIC/SPEED] knob will
increase the keying speed.
8. CW operation utilizing the CW paddle may
now commence.
paddle, the CW keying tone will automatically be
generated.
Setting the Keyer Weight (Dot/Dash) Ratio
A d j u s t t h e d o t / d a s h r a t i o f o r t h e b u i l t -
i n E l e c t r o n i c K e y e r (default weighting is
1. Press the [FUNC] key.
2.
WEIGHT].
3. Rotate the [MULTI] knob to set the weight to
the desired value. T h e a v a i l a b l e a d j u s t -
m e n t r a n g e i s a D o t / D a s h r a t i o o f
2 . 5 t o 4 . 5 .
4. Press the [FUNC] key to save the new set-
ting and exit the Setting Menu.
5. Press the [FUNC] key exit to normal opera-
tion.
Selecting the Keyer Operating Mode
The configuration of the Electronic Keyer may
be customized independently for the front and
rear KEY jacks of the FT DX101D. This permits
if desired. This permits the use of an electronic
keyer via the front jack and a straight key or com-
puter-driven keying line via the rear panel jack.
1. Press the [FUNC] key.
2.
3. Select [F KEYER TYPE] or [R KEYER TYPE].
4. Select the keyer to the desired mode. The
available selections are:
OFF
BUG
ELEKEY-A
-
ELEKEY-B
ELEKEY-Y
ACS
5. Press the [FUNC] key to save the new set-
ting and exit the Setting Menu.
6. Press the [FUNC] key exit to normal opera-
tion.
The built-in Electronic Keyer is turned
Dots will be generated automatically
by the keyer, but dashes must be sent
manually.
automatically transmitted upon pressing
either side of the paddle.
Pressing both sides of the paddle trans-
mits the currently generated "Dash"
Pressing both sides of the paddle trans-
mits the currently generated "Dash"
While transmitting the "Dash", the first
transmitted "Dot" will not be stored.
Same as "ELEKEY" except that the
spacing between characters is precisely
set by the keyer to be the same length
33