Yaesu FTDX101D Operation Manual page 7

TUNE
This is the on/off switch for the FTDX101D Auto-
matic Antenna Tuner.
the antenna tuner.
Press the [TUNE] key for about 1 second to start
"automatic tuning".
Since the transceiver transmits automati-
cally during automatic tuning, make sure to
connect an antenna or dummy load before
tuning up.
When the antenna or dummy load does not
match the impedance, "HI-SWR" will appear
on the touch panel.
VOX
This key enables automatic voice-actuated trans-
mitter switching. While VOX is activated, the LED
inside this key glows orange.
MOX
circuit to activate the transmitter.
ZIN/SPOT
ZIN
Touch [ZIN/SPOT] to cause the receiving frequency
to zero-in automatically while receiving the CW sig-
nal.
SPOT
Pressing and holding [ZIN/SPOT], the tone is out-
put from the speaker.
DISP
Each time the key is pressed, the display of the
scope screen changes as shown below.
Only "MAIN" or "SUB" will be displayed
Upper side: MAIN, Lower side: SUB
Left side: MAIN, Right side: SUB
Left side: MAIN, Right side: SUB
S.MENU
Settings related to scope display.
Setting scope sweep speed.
SPEED:
Adjust the peak signal color density.
PEAK:
MARKER: Marker display ON or OFF.
Changing scope display color.
COLOR:
Adjust the reference level.
LEVEL:
FUNC
screen where the operation settings for a variety of
to close the function menu screen.
SD memory card slot
You can use the commercially available SD memo-
ry card to save various settings, save the memory
5