Introduction - Danfoss VLT Decentral Drive FCD 302 Design Manual

Introduction

1 1
1 Introduction
1.1 How to Read the Design Guide
The design guide provides information required for
integration of the frequency converter in a diversity of
applications.
1.1.1 Additional Resources
•
®
VLT
information required to install and commission
the frequency converter.
•
®
VLT
Guide, for information about how to program the
unit, including complete parameter descriptions.
•
Modbus RTU Operating Instructions, for the
information required for controlling, monitoring,
and programming the frequency converter via
the built-in Modbus fieldbus.
•
®
VLT
Instructions, VLT
Guide, and VLT
Guide, for information required for controlling,
monitoring, and programming the frequency
converter via a fieldbus.
•
®
VLT
Instructions.
•
®
VLT
103 Installation Instructions.
•
®
VLT
Option MCB 108 Installation Instructions.
•
®
VLT
•
®
VLT
Operating Guide.
•
Approvals.
Technical literature and approvals are available online at
www.danfoss.com/en/search/?filter=type%3Adocumentation
%2Csegment%3Adds.
The following symbols are used in this manual:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
6
Decentral Drive FCD 302 Operating Guide, for
AutomationDrive FC 301/302 Programming
PROFIBUS Converter MCA 114 Operating
®
EtherNet/IP MCA 121 Installation
®
PROFINET MCA 120 Installation
Encoder Option MCB 102 Installation
AutomationDrive FC 300, Resolver Option MCB
AutomationDrive FC 300, Safe PLC Interface
Brake Resistor MCE 101 Design Guide.
Frequency Converters Safe Torque Off
Danfoss A/S © 05/2018 All rights reserved.
®
VLT Decentral Drive FCD 302
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTICE
Indicates important information, including situations that
may result in damage to equipment or property.
The following conventions are used in this manual:
•
•
•
•
1.2 Document and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
Edition
MG04H3xx EMC-correct Installation has been
Table 1.1 Document and Software Version
1.3 Definitions
1.3.1 Frequency Converter
I
VLT,MAX
Maximum output current.
I
VLT,N
Rated output current supplied by the frequency converter.
U
VLT,MAX
Maximum output voltage.
Numbered lists indicate procedures.
Bullet lists indicate other information and
description of illustrations.
Italicized text indicates:
- Cross-reference.
-
Link.
- Footnote.
- Parameter name.
-
Parameter group name.
- Parameter option.
All dimensions in drawings are in mm (inch).
Remarks
updated.
Software version
7.5x
MG04H302