Opti Onal Accessory: Rear Handlebars And Display - Janome Quilt Maker Pro 16 User Manual

User Manual
5. Aft er the bolts are in place, plug the cable
into the USB-style connecti on located on the
front-left side of the machine. The upper small
mini USB connecti on on the display is used to
connect to the machine. The bott om regular
USB connecti on on the right side of the display
is for USB power only, no data.
6. Remove the protecti ve plasti c from the touch-screen display before using.
To use the handlebar butt ons
Press the Up/Down
butt on to cycle the
needle a half sti tch.

Opti onal Accessory: Rear Handlebars and Display

To install the opti onal rear handlebars and display
 IMPORTANT: Install the rear handlebars and display aft er the front handlebars and display have
been installed.
Check that the machine is unplugged from the electrical outlet.
1.
 CAUTION: All power to the machine must be turned off when installing the rear handlebars. Failure
to do so can result in damage to the machine.
2. The rear handlebars come mounted to a bracket. Line up the four holes in the bracket with those on
the rear of the machine.
www.janome.com
QUILT MAKER PRO 16
Press the Speed Up or Speed Down butt ons to change the
sti tches per minute setti ng (manual mode) or sti tches per
inch (regulated mode).
Press the Start/Stop
butt on to start or stop
the machine from
sti tching.
15