Janome Quilt Maker Pro 16 User Manual page 21

User Manual
Laser Operati on and Safety
Be sure the laser is att ached to the machine and pointed downward toward the table before connecti ng it
to the port. Never point it in a directi on that would project the beam into someone's eyes. If the laser
should stop working, ensure the plug is fi rmly seated into the Quilt Maker Pro 16 laser port.
Laser Focus and Image Size
Focus the laser by turning the threaded housing surrounding the lens clockwise or counterclockwise.
The laser image can be adjusted to project a bigger or smaller dot, or focal size. The directi on of rotati on
needed is determined by the distance of the laser from the pantograph surface. Experiment by rotati ng
the threaded end to achieve your desired focal size.
Laser Safety
When using the laser stylus, observe the following basic safety precauti ons.
• Never shine directly into the eyes.
• The laser stylus should never be left on and unatt ended.
• Do not use the laser stylus as a toy.
• Pay close att enti on when the laser stylus is being used by or near children or pets.
• Use the laser stylus only for its intended use as described in this manual.
 NOTE: If you can't see the threaded housing, the lens may be threaded too far into the laser body.
You will need to use a large slott ed screwdriver to turn it counter clockwise unti l the housing is
visible. You can then rotate it with your fi ngerti ps to bring the light into focus. Be very careful to not
scratch the lens when using the screwdriver.
 CAUTION: Use of controls or adjustments or performance of procedures other than those specifi ed
herein may result in hazardous radiati on exposure.
www.janome.com
QUILT MAKER PRO 16
21