Power Cord; Handlebars And Display - Janome Quilt Maker Pro 16 User Manual

User Manual

Power Cord

To install the power cord
• Insert the cord into the power connector on the rear of the machine. Plug the three-prong end into
power source. Do not turn on the machine unti l the front handlebars and display are installed.
To disconnect the power cord
• Unplug the cord from the power outlet.
For more informati on, see Power Switch in the Using Your Machine secti on of this manual.
 NOTE: Make sure that the machine is off before plugging into power source. The rear power switch
should be in the 0, or off , positi on.

Handlebars and Display

 CAUTION: To prevent any electrical damage to the handlebars, always turn off all power to the
machine when connecti ng or disconnecti ng the handlebars.
To install the handlebars
1. Ensure that the machine is unplugged from the electrical outlet.
2. Locate the four M4 X 16 socketed cap screws
and the 3mm hex tool. Line up the four holes
on the front handlebar bracket with the tapped
holes on the front of the machine.
3. Start all four screw into the frame before
ti ghtening the screws.
4. Use the included 4 mm Hex tool to securely
fasten the handles to the front of the machine.
14
QUILT MAKER PRO 16
www.janome.com