Janome Quilt Maker Pro 16 User Manual page 49

Hide thumbs Also See for Quilt Maker Pro 16:
Table of Contents

Advertisement

User Manual
1. Aft er touching the Tools and Update butt ons and with the
red arrow fl ashing, insert the USB drive into the USB port on
the right side of the display (front or rear). Note: The other
display must be disconnected from the machine.
2. Touch the machine update butt on on the screen to update
the machine's soft ware.
 IMPORTANT: Do not remove the USB drive from the
port unti l the machine update butt on turns from blue
back to gray. This may take 1.5 to 2.5 minutes. If the USB
drive is removed prematurely the program will not fully
update. This will corrupt the machine soft ware making it
inoperable. The machine will then need to be returned
to Janome for repair.
3. The machine butt on will turn blue while the machine
soft ware is updati ng.
4. The Quilt Maker Pro 16 will search for the machine update fi le on the USB drive. When the update is
complete, the display screen butt on will once again turn gray.
To update the front display's soft ware
1. Aft er touching the Tools and Update butt ons and with the red arrow fl ashing, insert the USB drive into
the USB port on the right side of the display (front).
2. Touch the display update butt on on the screen to update the display soft ware.
3. The display screen will go blank unti l the soft ware is updated. Do not remove
the USB drive unti l the display screen returns.
 IMPORTANT: Do not remove the USB drive from the port unti l the machine display screen is once
again acti vely displayed. This may take 1.5 to 2.5 minutes. If the USB drive is removed prematurely
the program will not fully update. This will corrupt the display soft ware.
 If the display soft ware update is interrupted and corrupted, it is possible to reprogram the display
by putti ng it into the Boot Loader Programming Mode. This is done by holding down fi rmly the
needle up/down butt on and the - (minus) simultaneously while powering on the machine. Then
insert the USB drvie into the right USB port of the display and wait unti l the display screen returns.
Note: This cannot be done for the machine soft ware if it is interrupted.
www.janome.com
QUILT MAKER PRO 16
49

Advertisement

Table of Contents
loading

Table of Contents