Op琀椀 Onal Accessory: Rear Handlebars And Display - Janome Quilt Maker Pro 16 User Manual

User Manual
5. A昀琀 er the bolts are in place, plug the cable
into the USB-style connec琀椀 on located on the
front-le昀琀 side of the machine. The upper small
mini USB connec琀椀 on on the display is used to
connect to the machine. The bo琀琀 om regular
USB connec琀椀 on on the right side of the display
is for USB power only, no data.
6. Remove the protec琀椀 ve plas琀椀 c from the touch-screen display before using.
To use the handlebar bu琀琀 ons
Press the Up/Down
bu琀琀 on to cycle the
needle a half s琀椀 tch.
Op琀椀 onal Accessory: Rear Handlebars and Display
To install the op琀椀 onal rear handlebars and display
 IMPORTANT: Install the rear handlebars and display a昀琀 er the front handlebars and display have
been installed.
Check that the machine is unplugged from the electrical outlet.
1.
 CAUTION: All power to the machine must be turned off when installing the rear handlebars. Failure
to do so can result in damage to the machine.
2. The rear handlebars come mounted to a bracket. Line up the four holes in the bracket with those on
the rear of the machine.
www.janome.com
QUILT MAKER PRO 16
Press the Speed Up or Speed Down bu琀琀 ons to change the
s琀椀 tches per minute se琀� ng (manual mode) or s琀椀 tches per
inch (regulated mode).
Press the Start/Stop
bu琀琀 on to start or stop
the machine from
s琀椀 tching.
15