Janome Quilt Maker Pro 16 User Manual page 16

User Manual
3. Slide the four bolts into holes unti l they stop. Hand ti ghten, and then use the 3 mm wrench to securely
fasten the handles to the back of the machine.
4. Aft er the four bolts are in place, plug the small connector end of the cable into the port on the left side
of the display. Push the plug securely into place.
5. Securely plug the other end of the cable into the port on the back of the machine below
the handlebars.
 NOTE: See the instructi ons that accompany the Rear Handlebars and Display.
 IMPORTANT: Aft er the rear handlebars have been completely installed and plugged in, test them by
turning on the Quilt Maker Pro 16 and looking at the rear display. If nothing appears on the screen,
check that both the front and rear handlebar cables are plugged in securely, that your machine is
turned on, and that the power cord is plugged into the machine as well as a power source.
16
QUILT MAKER PRO 16
www.janome.com