Overview
Power window switches
Operating requirements
The windows can be operated under the
following conditions.
▷
Standby state is established.
▷
Drive-ready state is established.
▷
For a short while after idle state has been es‐
tablished.
▷
The remote control is in the interior.
Opening
▷
Push the switch as far as the resist‐
ance point.
The window opens as long as the switch is
held.
▷
Push the switch past the resistance
point.
The window is opened automatically. The
movement is stopped by pressing the switch
again.
Closing
▷
Pull the switch as far as the resist‐
ance point.
The window closes as long as the switch is
held.
▷
Pull the switch past the resistance
point.
Opening and closing
Online Edition for Part no. xxx - X/18
The window closes automatically if the door
is closed. Pulling the switch again stops the
movement.
Closing using Comfort Access, see page 81.
Anti-trap mechanism
General
If the closing force exceeds a certain value when
a window is closing, the closing operation is in‐
terrupted.
The window is opened slightly.
Safety note
WARNING
Accessories on the windows, for example aer‐
ials, can impair the anti-trap mechanism. There
is a danger of injury. Do not attach any acces‐
sories in the area of movement of the windows.
Closing without the anti-trap
mechanism
If an external danger or ice does not allow you to
close the windows normally, proceed as follows:
1.
Pull the switch past the resistance
point and hold it there.
The window is closed with a restricted anti-
trap mechanism. If the closing force exceeds
a certain value, the closing operation is inter‐
rupted.
2.
Pull the switch past the resistance
point again within approximately 4 seconds
and hold it there.
The window is closed without the anti-trap
mechanism.
CONTROLS
97