BMW Z4 Roadster Owner's Handbook Manual page 237

Reprogramming individual
buttons
1. Switch on standby state.
2. Press and hold the button on the rear-view
mirror to be programmed.
3. As soon as the LED on the rear-view mirror
flashes orange after approximately 20 sec‐
onds, release the button.
4. Hold the hand-held transmitter for the system
to be operated approximately 2.5 to 30 cm, 1
to 12 in away from the buttons on the rear-
view mirror. The distance required depends
on the hand-held transmitter.
5. Press and hold the button for the desired
function on the hand-held transmitter.
6. The LED can illuminate in various ways.
▷ The LED is illuminated green: the pro‐
gramming process is complete.
Release the button.
▷ The LED flashes rapidly: the hand-held
transmitter has been detected, but pro‐
gramming is not complete.
Press and hold the button on the rear-
view mirror for 2 seconds, then release.
Repeat this process three times to com‐
plete programming.
If the universal remote control is still not
operational, continue from Special in‐
struction for alternating-code radio sys‐
tems.
▷ The LED does not flash green after
60 seconds: programming could not be
completed.
Repeat steps 3 to 6.
If the programming process is not complete, the
previous programming will be retained.
Interior equipment
Online Edition for Part no. xxx - X/18
Operation
WARNING
Parts of the body can be trapped when operat‐
ing radio-controlled systems with the
integrated universal remote control, for example
garage door. There is a danger of injury or
damage to property. When programming and
operating, make sure that the area of move‐
ment of the particular system is kept clear. Also
follow the safety notes supplied with the hand-
held transmitter.
The system, for example the garage door, can be
operated using the button on the rear-view mir‐
ror when drive-ready state or standby state is
switched on. To do this, press and hold the but‐
ton within the reception range of the system until
the function is triggered. The LED on the rear-
view mirror illuminates continuously when the
radio signal is being transmitted.
Deleting saved functions
All saved functions are deleted. It is not possible
to delete functions individually.
Simultaneously press and hold the two outer
buttons on the rear-view mirror for approxi‐
mately. 10 seconds until the LED flashes green
rapidly.
Sun visor
Glare protection
Fold the sun visor downwards or upwards.
Glare protection from the side
Folding out
1. Fold the sun visor downwards.
2. Remove the sun visor from the bracket and
pivot it sideways to the side window.
CONTROLS
237