BMW Z4 Roadster Owner's Handbook Manual page 117

rectly and the ISOFIX child restraint system is
firmly positioned against the backrest.
Position
Not for Australia/New Zealand:
The brackets for the lower ISOFIX anchors are
located in the gap between the seat and back‐
rest.
Before fitting ISOFIX child
restraints
Pull the seat belt away from the area of the child
seat mountings.
Fitting ISOFIX child restraint
systems
1. Install the child restraint system, see the
manufacturer's instructions.
2. Make sure that both ISOFIX anchors are
locked correctly in place.
i-Size child restraint systems
General
i-Size is a regulation for child restraint systems,
which is used for the approval of child restraint
systems.
Carrying children safely
Online Edition for Part no. xxx - X/18
Symbol Meaning
If this symbol is seen in the vehi‐
cle, the vehicle has been ap‐
proved in accordance with i-
Size. The symbol shows the
mounts for the system's lower
anchors.
The corresponding symbol
shows the mounting point for
the upper retaining strap.
Mounts for the upper
ISOFIX retaining strap
Safety notes
WARNING
If the upper retaining strap is used incorrectly
with the child restraint system, the protective
effect may be reduced. There is a danger of in‐
jury. Make sure that the upper retaining strap is
not routed to the upper attachment strap over
sharp edges and that it is not twisted.
NOTE
The mounting points for the upper retaining
straps of child restraint systems are only inten‐
ded for these retaining straps. The mounting
points can be damaged if other objects are at‐
tached. There is a danger of damage to prop‐
erty. Only attach child restraint systems to the
upper retaining straps.
CONTROLS
117