Kärcher SGV 6/5 Service Manual page 67

Error Display
codes
E5 Empty O
wastewa-
ter.
E8 Filling pro- O
cedure
please wait
E10 Seclect O
rinsing pro-
gramme
E11 Heating O
E12 Service O
fault: E12
E13 Service O
fault: E13
E14 Service O
fault: E14
E15 Service O
fault: E15
E16 Service O
fault: 16
Fault
Display on, pump without function
O
X
X
O
O
Cause
Performance electronics
Check the fuse.
Cause
O
O
O
Correction
Replace defective fuse.
Fuse 6.3A (slow-blow)
English 5.906-590.0 Rev. 01 (05/17)
Correction
 Insert the wastewater con-
tainer properly and lock it.
 Empty the wastewater res-
ervoir.
 Check the float in the tank
for mobility.
Note
 Information only appears
upon the initial filling.
Note
 Information appears after
operation with detergent.
 No steam operation possi-
ble.
Note
 Information only appears
upon the initial filling.
 Check the connector plug
"hand tool" on the device
for proper seating.
 The connector plug "hand
tool" on the device must be
completely dry.
 Check the connector plug
"hand tool" on the device
for proper seating.
 The connector plug "hand
tool" on the device must be
completely dry.
 Actuate reset button µc-
card.
Note
 Steam boiler should be
descaled.
See chapter:
Descaling steam boiler
Note
 Steam boiler must be
descaled.
See chapter:
Descaling steam boiler
 Check fan for soiling or
damage.
 Check the connector.
 Check plug contacts on the
power electronics (power
card).
 Check ribbon cable that
connects the power card
with μc-card.
If defective, exchange μc-
card.
Note
Further tests see:
Table of measurement values
67