Getting Started; Device Overview; Mounting And Powering The Device In Your Vehicle; Installing The Ball Mount Adapter - Garmin OVERLANDER Owner's Manual

Getting Started

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
1
Update the maps and software on your device
Maps and Software Using a Wi
2
Set up a Garmin Explore
page 12).
3
Mount the device in your vehicle and connect it to power

(Mounting and Powering the Device in Your Vehicle,

page 1).
4
Set up a vehicle profile (Vehicle Profiles, page
5
Navigate to your destination

Device Overview

Microphone for hands-free calling
Volume control
Power key
Micro USB power and data port
Map and data memory card slot
3.5mm audio jack
Magnetic mount interface with 14 pin connector
Speaker
Mounting and Powering the Device in Your
Vehicle
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Both the device and its mount contain magnets. Under certain
circumstances, magnets may cause interference with some
internal medical devices and electronic devices, including
pacemakers, insulin pumps, or hard drives in laptop computers.
Keep the device away from medical devices and electronic
devices.
Getting Started
WARNING
(Updating
‑ Fi Network, page
18).
™ account (Garmin Explore,
3).
(Starting a Route, page
WARNING
Before you use your device on battery power, you should charge
it.
1 Press the mount
into place.
2
Open the lever
4).
and flip the lever back toward the windshield.
The lever must be oriented toward the top of the windshield.
3 Extend the suction cup arm
4
If necessary, rotate the mount so the Garmin
right-side up.
5
Plug the vehicle power cable
6
Place the back of the device onto the mount.
7
Plug the other end of the vehicle power cable into a power
outlet in your vehicle.

Installing the Ball Mount Adapter

Your device includes a one-inch ball mount compatible with
other third-party mounting solutions.
Secure the ball adapter
screws .
onto the suction cup ball
, press the suction cup to the windshield,
.
into the port on the mount.
to the mount using the included
until it snaps
logo faces
®
1