Control Panel Buttons - Bailey Approach Autograph Series Owner's Manual

Control Panel Buttons

When pressed this will switch the power on to all
non-essential accessories.
To shut down the control panel completely,
press and hold down the master switch; the set
time will be lost and will need to be reset when
restarted. The control panel can also be shut
down from the User Settings menu.
NOTE: The alarm, radio and fridge
still receive power when the master
switch is off.
The following functions can only be controlled
when the master switch is turned on:
Lights Switch
When pressed, will enable all lights
to be turned on by their individual
switches.
Pump Switch
When pressed will enable or disable
the water pump. Press and hold
this button to force the internal
pump to run; see "Notifications and
Warnings" section for pump running
notification.
Awning Switch
When pressed will turn on the
awning light.
Navigation Buttons
Use the UP or DOWN arrows to navigate through
the menus.
Press ENTER to change the setting or additional
settings (if available).
Notification and Warning Icons
There are a number of icons that can appear at
the top of the time screen.
Refer to the table below for a brief description
of each icon.
Icon
P
Internal Pump is running.
Leisure battery is below 12.2V.
v
Over 12A of current is being
drawn from the leisure battery.
The fresh water tank level is
below 10%.
The waste water tank is over
75% full.
The living space is being powered
!
by the vehicle's battery rather
than the leisure battery.
The 230V mains is connected.
A connected gas appliance is
using the gas supply.
When a new warning is triggered it may be
accompanied by a pop up alarm screen if the
appropriate User Setting is enabled. When this
happens the control panel will flash and beep
until the warning is acknowledged by pressing
the ENTER button.
Description
81