Settings - Bailey Approach Autograph Series Owner's Manual

Settings

Contrast:
Adjusts the contrast of the LCD display if you
are finding it difficult to read.
Sound:
Enables or disables the sound when a button is
pressed.
Chg V Batt:
When enabled the vehicle battery will be
charged while 230V mains is connected. The
leisure battery will also be charged at the same
time.
Standby:
Sets how long the control panel waits for a
button press before going into standby.
Water Low:
Enables or disables the warning alarm when the
water tank is low;
—Press ENTER to acknowledge an alarm that
has triggered. The warning will only re-arm
when the waterlevel increases by 25%.
Waste High:
Enables or disables the warning alarm when the
waste tank is high;
—Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the waste level is reduced to 50%.
230V Lost:
Enables or disables the warning alarm when the
230V mains connection is lost;
—Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the 230V connection is restored.
Amps High:
Enables or disables the warning alarm when
the current drawn from the leisure battery
exceeds 12A;
—Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the current is reduced below 5A.
Veh Batt Low:
Enables or disables the warning alarm when the
vehicle battery voltage is less than 11V;
—Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the vehicle battery is charged over 13V.
Leis Batt Low:
Enables or disables the warning alarm when the
leisure battery voltage is less than 11V;
—Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the leisure battery is charged over 13V.
Auto Battery:
When enabled the power source will switch
to vehicle battery automatically if the leisure
battery is low. When a charging voltage is
detected, the power source will switch back to
leisure battery.
Shut down now:
Pressing ENTER will shut the control panel down
into its low power mode. The master switch will
be turned off and the clock will lose its time.
—Press any button to turn the panel back on.
Firmware:
Displays the current firmware version installed
on the control panel.
Exit to Main Menu:
Saves any changes to the settings and navigates
back to the main menu.
83