Manual Tank Filling; Whale Watermaster Pressure Pump - Bailey Approach Autograph Series Owner's Manual

Manual Tank Filling

The tank can be filled manually using a standard
hose inserted directly into the tank.
The fresh water tank can be accessed via the
hatch in the floor of your motorhome.
1. Remove the hatch cover.
2. Unscrew the tank filler cap.
3. Insert hose and turn on tap.
4. Monitor the level of the tank via the control
panel or visually within the tank.
5. Turn off and remove hose.
6. Replace Tank cap.
7. Replace hatch cover.
Whale Watermaster Pressure
Pump
After the onboard water tank has been filled,
the water system should be primed as follows:
1. Check that the ancillary power supply to
the pump on the control panel is ON.
2. Open one hot tap, e.g. kitchen sink; water
will flow from the open tap after filling the
water heater. This could take a few minutes
if the water heater was empty.
3. When the water is flowing smoothly, close
the hot tap and open the cold tap to expel
any air left in the plumbing system.
4. Repeat with all taps to expel any air in the
system - remember to remove the shower
head.
5. The system is now ready for use.
Should the flow rate from the taps be reduced
at any time, check the grit filter, at the side of
the pump.
39