Bailey Approach Autograph Series Owner's Manual page 160

158
The Remis Window Blinds
Operating Your Motorhome Habitation
Blinds
NOTE: blinds should not be in the
down position when the vehicle is
travelling or when in storage for
extended periods.
The sun screen is housed at the bottom and
the fly screen at the top of the blind. To open
either hold the cross bar and pull up or down.
Both blinds can be fully extended to totally
cover the window or can meet at any position
to give sun shading/privacy and protection
from insects entering the vehicle.
The blinds are pre-set to the correct tension.
If re-tensioning is required please follow these
steps:
1. The blind needs to be taken down from the
wall by unscrewing the 4 corner screws.
2. Lay the blind face down on a table with the
cross bars of both blinds meeting in the
middle. The black cords re-tension the fly
screen and the white cords re-tension the
sun screen.
3. The cords are fixed at either side with a
screw. Loosen this screw and gently pull
the cord 5mm tighter and repeat on the
other side ensuring the cross bar is level.
4. Test the tension. This process can be
repeated if necessary.
5. The blinds over the kitchen sink and in the
bathroom are of a different construction
and can be re-tensioned while fixed to the
wall. On the side of the cassettes are two
plastic screw heads. Using a screwdriver
turn these gently clockwise until the
correct tension is reached. Test the
tension after each turn.
Cleaning
• Avoid using aggressive cleaning agents
(solvents/abrasives).
• Clean the frame elements of the front and
side systems with a damp cloth and mild
soap solution.
• Blinds should only be dusted lightly with a
soft cloth.