Putting into Service
7
Putting into Service
Behaviour after switch-on
There may be a delay of several seconds between switch-on and the unit being ready for
operation.
The application software can then be installed and started.
7.1
Activating the setup
If you do not press the SETUP button within 2 seconds, the "PMIStart.cmd" script file will be
run. "PMIStart.cmd" is a batch file which is processed step by step.
Fig.: Activating Setup
7.2
Control Panel
All system settings can be made from the Control Panel of Windows Embedded CE 6.0.
Special features and device-specific settings are described in the following.
Operating Manual PMI 5
1002241-EN-07
28