4. Attach upper handle brace to lower handle using
corresponding hardware. Then repeat this step on the
other side.
7. Attach rod end to rod (as in step 5).
8. Attach nozzle door rod to the lever with
nozzle door closed and lever in hose kit
position.
NOTE: Check to see nozzle door open and
close all the way (see page 15). Tighten or
loosen the rod end (164) for any
adjustments.
Form No F012507A
MV650H PUSH Vacuum Owner's Manual
- Two 1/2" wrenches.
9. Install cable ty wraps.
Two 9/16"
wrenches.
5. Attach rod end (164) to the nozzle door rod then
secure in place by tightening jam nut.
6. Attach nozzle door rod to the nozzle door using
corresponding hardware.
NOTE: It is easier to do this with nozzle door closed.
HERE
HERE
11
- Two 9/16" wrenches.
10. Reconnect spark plug wire.
11. Attach the bag.
Part No 840186