Rear Drive & Slip Clutch Installation; Blade Assembly - Woods 208-2 Operator's Manual

1. Bolt
2. Lock clip
3. Keyhole plate
4. Spacer
5. Spacer
6. Spacer
7. Crossbar
8. Blade
9. Pin
Figure 19. Blade Assembly
32394 (Rev. 9/3/2004)
REAR DRIVE & SLIP CLUTCH
INSTALLATION
DB1954
Place keys (3) in input shaft of center gearbox. Install
slip clutch (1) by aligning keys and bolt hole, and slide
over shaft. Secure with bolts (5 & 7) and nuts (6 & 8).
Torque according to values given on the bolt torque
chart, page 68.
Tri-lobe and splined shaft drives install similarly to 1-
1/2" square shaft drive.
Attach clutch shield (2) to cutter frame with sheet metal
screws (4).
1. Slip clutch
2. Clutch shield
3. Key
4. Sheet metal screw
5. 7/16 x 3-1/2 Bolt
6. 7/16 Locknut
Figure 20. Slip Clutch Installation
Assembly 29
DB2195A
7. 5/8 NC x 3-1/2 Hex
head cap screw
8. 5/8 NC Hex nut
9. Tri-lobe drive
(mounted)
10. Splined drive
(pull-type)