Lubrication Points - Woods 208-2 Operator's Manual

REF
NO
1 Tailwheel hub
2 Ratchet height adjustment (optional)
3 Tailwheel pivot and hub (single or dual optional on mounted units)
4 PTO Shaft, (mounted) lube all four sides of shaft and both U-joints (see * in fig-
ure 6)
5 PTO Shaft, (pull-type) access under shield; lube all four side of shaft next to
round tube
6 Gearboxes, check that all three are half full with a high quality gear lubricant
with a viscosity index of 80W or 90W and an API service rating of GL-4 or 5 in
gearbox(es)
7 PTO Shaft, front and rear U-joints
8 Center U-joint on 3-joint drive (pull-type)
9 Torsion bars - To prevent torsion bars from seizing and/or binding and causing
excessive loads on gearbox bearings, lubricate as detailed
10 Hanger bearing assembly
32394 (Rev. 9/3/2004)
:
DESCRIPTION
Figure 6. Lubrication Points
Owner Service 17
DB1136A
FREQUENCY
10 hrs.
100 hrs.
10 hrs.
Daily
Daily
Daily
10 hrs.
10 hrs.
At storage and
start of season
10 hrs.