H&S 5126 Operator's Manual page 27

FRONT & REAR AUGER SLIDES
The front and rear auger slide assemblies are retained
by adjustment plates with diagonal slots. To adjust,
loosen retaining hardware and drive the plates
downward with a hammer until the slide assembly is
snug against the tank, then re-tighten the retaining
hardware. Grease the slide assembly to ensure a leak
free seal.
DISCHARGE GATE
The discharge gate is retained by adjustable
angles that secure the gate to the tank
through diagonal slots. To adjust, loosen
retaining hardware and drive the angles
downward with a hammer until the discharge
gate is snug against the tank, then re-tighten
the retaining hardware. Grease the discharge
gate to ensure a leak free seal.
ADJUSTMENTS
-25-