Next NI2400 User Manual page 56

5
DATALOGGER
NI2400
You can also click on Data in the left menu and get the Data page with the list of all
data source configured in the portal grouped by device:
You can add data source also from this page following a procedure similar to the one
just described.
CREATE THE DASHBOARD AND ADD WIDGETS
You can create a new dashboard by selecting Dashboard in the left menu and clicking
on Add dashboard in the top right page. You can add more dashboards in the same
portal and in this page you will have the list of all added dashboards:
By clicking on the dashboard thumbnail you finally have access to the dashboard. Here
you can add widgets needed to monitor the data sources by clicking on ADD WIDGET
button:
www.ruggedaq.com
Figure 104
Figure 105
0110
5
DATALOGGER
NI2400
By clicking on this button you can select a widget to be added in the list of all available
buttons:
Since OM devices send data to Exosite portal using a custom protocol not all the wid-
gets could be used.
For data source visualization only the following widgets can be used:
Colum -Next Industries-
Gauge -Next Industries-
Image Overlay -Next Industries-
Line chart -Next Industries-
Table -Next Industries-
For generic info visualization (map, device list, event list, event log ...) every widget
can be used.
Once widget type is selected you have name it and than, by pressing on CONTINUE,
you can configure the widget with the following page:
www.ruggedaq.com
Figure 106
Figure 107
0111