Summary of Contents for Horizon Hobby ECX Temper ECX01015T1
Page 1
® 1:18 GEN2 4WD BRUSHED ROCK CRAWLER RTR ECX01015T1/T2 Congratulations on your purchase of the ECX Temper Gen2 4WD Brushed Rock ® ® Crawler. This model introduces you to the sport of RC driving. INSTRUCTION MANUAL Herzlichen Glückwunsch zum Kauf des ECX Temper Gen2 4WD Brushed Rock Crawler.
Page 2
Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
Wet Conditions Maintenance • Spray the bearings, drive train, fasteners and other metal parts with a water-displacing light oil or lubricant. Do not spray the motor. • Remove the battery pack(s) and dry the contacts. If you have an air • Let the vehicle air dry before you store it.
1. Connect the NiMH battery to the battery charger. • Always inspect the battery before charging. 2. Connect the charger to an AC power outlet. • Always terminate all processes and contact Horizon Hobby if the 3. Allow the NiMH battery to charge for 9 hours. product malfunctions.
TRANSMITTER CONTROLS Reverse Switch Battery Level Indicator Solid Red: Battery voltage is good (above 4V) Flashing Red: Battery voltage Allows you to change the direction of steering is critically low (below 4V). (ST. REV) and throttle (TH. REV) controls (Ensure Replace transmitter batteries proper function with a radio system test) Throttle Trim...
BINDING The included transmitter and receiver are bound at the factory. If you need to rebind, follow the instructions below. 1. Power ON the receiver. The receiver LED flashes slowly. 2. Insert the bind plug into the receiver’s binding pins. The receiver LED flashes rapidly.
OPERATION • ALWAYS turn on your transmitter before you turn on the receiver • ALWAYS operate your vehicle in a wide open area. Operating the in the vehicle. Always power off the receiver before turning your vehicle in a small space or indoors can cause overheating at low transmitter off.
MAINTENANCE SETTING THE GEAR MESH The gear mesh has already been set at the factory. Setting the gear mesh is only necessary when changing motors or gears. You must remove the vehicle’s gear cover (A) to make this adjustment. Proper gear mesh (how the gear teeth meet) is important to the performance of the vehicle.
Product, (iv) attempted service by shipping carton. Please note that original boxes may be included, but are not anyone other than a Horizon Hobby authorized service center, (v) Product not designed to withstand the rigors of shipping without additional protection.
Instructions for disposal of WEEE by EU Compliance Statement: Horizon Hobby, LLC hereby declares that this product is in compliance with the users in the European Union essential requirements and other relevant provisions of the This product must not be disposed of with other waste.
Optional Parts / Optionale Teile / Liste des options / Elenco parti opzionali Part # Description Beschreibung Description Descrizione 7.2V 1100mAh NiMH 6C Flache Akkus 6C 3+3 Ni-MH Batterie plate 6C 3+3 Ni-MH 7,2V Batteria piatta 6C 3+3 NiMH DYNB0105EC 3+3, EC3 7,2V 1100mA, EC3 1100mA, prise EC3...
Page 13
PARTS DIAGRAM | EXPLOSIONSZEICHNUNG | VUE ÉCLATÉE DES PIÈCES | ESPLOSO DEL MODELLO CON REFERENZA PEZZI ECX215000 (M2x6mm) ECX210012 ECX11008 ECX215000 (M2x8mm) ECX210013 ECX215000 (Yellow // Gelb // Jaune // Giallo) ECX210012 (M2x6mm) ECX210014 ECX211023 (Blue // Blau // Bleu // Blu) ECX215000 (M4x4mm) ECX215000...
Page 14
ECX41013 ECX216004 PARTS DIAGRAM | EXPLOSIONSZEICHNUNG | VUE ÉCLATÉE DES PIÈCES | (M4) ECX41011 (Black wheel with yellow beadlock // ESPLOSO DEL MODELLO CON REFERENZA PEZZI Schwarzes Rad mit gelbem Beadlock // Roue noire avec verrou de talon jaune // Ruota nera con Beadlock giallo) ECX41012 (Gray wheel with blue beadlock // REAR AXLE AND SUSPENSION | HINTERACHSE UND AUFHÄNGUNG...
Need help?
Do you have a question about the ECX Temper ECX01015T1 and is the answer not in the manual?
Questions and answers