Summary of Contents for Horizon Hobby E-FLITE EC-1500
Page 1
EC-1500 1.5m Scan the QR code and select the Manuals and Support quick links from the product page for the most up-to-date manual information. Scannen Sie den QR-Code und wählen Sie auf der Produktseite die Quicklinks Handbücher und Unterstützung, um die aktuellsten Informationen zu Handbücher.
This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance.
Registration Specifications Wingspan 60.1" (1527mm) Register your product today to join our mailing list and keep Length 46.9" (1190mm) up to date with product updates, offers and E-flite news. ® Without Battery: 83.7oz (2373g) Weight With Recommended 4S 4000mAh Flight Battery: 97.2oz (2755g) Included Equipment Receiver Spektrum...
Transmitter Setup BNF Dual Rates NX Series Transmitter Setup Take first flights in Low Rate. For landings, use high rate elevator. 1. Power ON your transmitter, click on scroll wheel, roll to System Setup and click the scroll wheel. Choose yes. NOTICE: To ensure AS3X technology functions properly, do not lower rate ®...
Model Assembly Vertical Stabilizer Installation 1. Slide the leading edge of the vertical stabilizer into place first and then insert the vertical stabilizer into place. Verify the integrated servo connector makes a good connection. 2. Secure the vertical stabilizer with two M3 x 24mm countersunk self tapping screws using a phillips screwdriver (PH#1).
Page 6
Aileron to center section joiner Flap to center section joiner Flap Configuration IMPORTANT: The flaps and ailerons of the E-flite EC-1500 require the installation (Left Wing Panel shown) of the included joiner either between the inner and outer flap sections OR the outer flap section and the aileron.
Propeller Installation WARNING: Never install a cracked, nicked or otherwise damaged propeller or spinner. NOTICE: If the propeller is not balanced, the aircraft may vibrate, causing the stabilization system to not operate correctly and/or decrease the life of the servos. 1.
Battery Installation and ESC Arming The Spektrum 4000mAh 4S 14.8V Smart 30C; IC3 Li-Po battery (SPMX40004S30) is recommended. A 3S or 4S 3200-5000mAh LiPo battery with an IC3 or EC3 connector is required, refer to the Optional Parts List for other recommended batteries.
General Binding Tips and Failsafe BNF • The included receiver has been specifically programmed for operation of this • Once bound, the receiver will retain its bind settings for that transmitter until you aircraft. Refer to the receiver manual for correct setup if the receiver is replaced. re-bind.
Control Surface Centering After assembly and transmitter setup, confirm that the control surfaces are centered. The model must be powered up, bound to the transmitter in AS3X mode, with the throttle left at zero. When enabled, SAFE mode is active at power up. AS3X mode is activated when the throttle is raised above 25% for the first time after being powered on.
SAFE Select Switch Designation BNF ® Assigning a Switch Once SAFE Select is enabled, you can choose to fly in SAFE mode full-time, or assign a switch. Any switch on any channel between 5 and 9 can be used on your 1.
Dual Rates and Control Throws Program your transmitter to set the rates and control throws based on your Advanced Intermediate Pilots experience level. These values have been tested and are a good starting point to Pilots achieve successful first flight. Low Rate High Rate Low Rate...
Control Surface Direction Switch on the transmitter and connect the battery. Use the transmitter to operate Transmitter command Control Surface Response the aileron, elevator, rudder and flap controls. View the aircraft from the rear when checking the control directions. Elevator 1.
In Flight Trimming During your first flight, trim the aircraft for level flight at 3/4 throttle. Make small trim adjustments with your transmitter’s trim switches to straighten the aircraft’s flight path. After adjusting trim do not touch the control sticks for 3 seconds. This allows the receiver to learn the correct settings to optimize AS3X performance.
Receiver Installation (PNP) The Spektrum AR8360T receiver is recommended for this airplane. If you choose to install another receiver, ensure that it is at least a 6-channel full range (sport) AR8360T Port receiver. Refer to your receiver manual for correct installation and operation instructions.
Ski Installation (Optional) 1. Position the skis so they are pointed forward and aligned with the axles 2. Press the skis onto the axles to snap them in place. 3. Attach a piece of string from the front of the ski to the nose wheel steering assembly as shown to prevent the nose of the front ski from dipping down.
Float Installation (Optional, floats not included) Float Set (EFLA550), Float Hardware (EFL5771) 1. Pull the nose wheel assembly from the nose wheel steering bracket. The main wheels may be left on the airplane or removed for operation on floats. 2. Insert the water rudder steering assembly into the nose wheel steering bracket. 3.
Troubleshooting Guide AS3X BNF Problem Possible Cause Solution Damaged propeller or spinner Replace propeller or spinner Imbalanced propeller Balance the propeller Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed Oscillation Loose receiver Align and secure receiver in fuselage Loose aircraft controls Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface) Worn parts...
Important Federal Aviation Administration (FAA) Information Use the QR code below to learn more about the Recreational UAS Safety Test If your model aircraft weighs more than .55lbs or 250 grams, you are required by (TRUST), as was introduced by the 2018 FAA Reauthorization Bill. This free test is the FAA to register as a recreational flyer and apply your registration number to required by the FAA for all recreational flyers in the United States.
What this Warranty Covers any assistance. For questions or assistance, please visit our website at www. Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product horizonhobby.com, submit a Product Support Inquiry, or call the toll free telephone purchased (the “Product”) will be free from defects in materials and workmanship...
Champaign, IL 61822 USA Directive - Amending 2011/65/EU Annex II 2015/863. EU Importer of Record: EC-1500 BNF Basic (EFL15750); Hereby, Horizon Hobby, LLC declares that the Horizon Hobby, GmbH device is in compliance with the following: EU Radio Equipment Directive 2014/53/ Hanskampring 9 EU;...
Page 23
E-flite, Avian, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, Plug-N-Play, AS3X, SAFE, the SAFE logo, ModelMatch, IC3, EC3, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Need help?
Do you have a question about the E-FLITE EC-1500 and is the answer not in the manual?
Questions and answers