Troubleshooting - Klutch MIG 140i Owner's Manual

•
Disconnect input power before installing, maintaining or servicing this equipment. Lockout/tag out
input power according to OSHA 29 CFR 1910.147.
Maintain the welder by adopting a program of conscientious repair and maintenance in accordance with
the following recommended procedures. It is recommended that the general condition of any tool be
examined before it is used. Keep your tool in good repair. Keep all cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Keep
handles dry, clean, and free from oil and grease. The following chart is based on a normal operation
schedule.
Maintenance Interval
Before Each Use
Every 3 Months
ELECTRIC SHOCK CAN KILL!
•
Touching live electrical parts can cause fatal shocks or severe burns. Do not touch live electrical
parts.
•
Wear dry, hole-free insulating gloves and body protection.
•
Disconnect input power before installing, maintaining or servicing this equipment.
•
Lockout/tag out input power according to OSHA 29 CFR 1910.147.
Be aware that the Electrode will be electrically HOT when the Input Power Switch on the welder is
turned on.
Maintenance Point
Inspect all cords and power cables. Replace any cords or power cables
that are damaged or cracked.
Inspect all warning and caution labels affixed to this unit. If they are
worn, torn or otherwise unreadable, then replace the warning labels.
Inspect and clean and tighten all weld power connections.

Troubleshooting

⚠WARNING
⚠CAUTION
Page 26 of 31