Table of Contents
Advertisement
■ To select a tone
1.
Use the bp^ button to cycle through settings
until the "^TONE" indicator to the right of the
button is lit.
The currently selected tone category name and tone
name will be shown on the display.
[
]
T O N E
P I A N O
0 0 1 : G r P n o C o n c e r t
T : 1 2 0
Tone name
2.
Use TONE category buttons bq through cl to
select a tone category.
• Touching one of the TONE category buttons switches
to the tone that was selected the last time that tone
category was exited.
• Each touch of the TONE category button of the
currently selected tone category will cycle to the next
sub-category of that category.
3.
Use the bk – and bl + buttons to select a tone.
• To jump to the first tone in the current category, touch
bk – and bl + at the same time.
■ Guitar Tones
The built-in guitar tones of this Digital Piano include strum
noise and other sound effects that are applied in accordance
with the pitch (note number) and/or intensity (velocity) of the
notes being played.
■ Versatile Tones
The Digital Piano's built-in tones include "versatile tones"
(three guitar tones, two bass tones, and two brass tones) that
can be used for creating computer music. Versatile tones
assign performance sounds that are characteristic of a
particular musical instrument (such as a guitar glissando, fret
noise, etc.) to each keyboard key (note) and velocity. For
information about the sounds assigned for each versatile tone
and velocity, see
"Versatile Tone
Category name
Map" (page EN-75).
Layering Two Tones
Layering makes it possible to sound with two different tones at
the same time. The tone that is layered onto another tone is
the "Upper2 part tone", which in this manual is referred to as
the "Upper2 tone". The tone upon which the Upper2 tone is
layered is the "Upper1 part tone", which is referred to as the
"Upper1 tone".
■ To layer two tones
1.
Use the procedure under
(page EN-15) to select the Upper1 tone.
2.
Use the bp^ button to cycle through settings
until the "^CTRL" indicator to the right of the
button is lit.
3.
Touch cl LAYER to enable the layer function,
which is indicated by "LY" on the display.
4.
Use the bp^ button to cycle through settings
until the "^TONE" indicator to the right of the
button is lit. Next, perform the operation under
"To select a
tone" (page EN-15) to select the
Upper2 tone.
Upper2
"
[
T O N E
]
U 2 S T R I N G S
0 0 2 : M e l l o w S t r . 1
T : 1 2 0
• You can adjust the volume of the Upper1 and Upper2 parts,
and configure other part settings. For details, see
"Configuring Layer and Split
Digital Piano Operations
Upper1
Upper2
"To select a
tone"
" indicator
L Y
Layer enabled indicator
Settings" (page EN-17).
EN-15
Advertisement
Table of Contents
