Table of Contents
Advertisement
■ Touch Button Light Auto Off
To save power, you can configure a setting that will turn off all
button lights, except for the 3 mode selector button, after a
certain period of non-operation. Use FUNCTION parameter
102
("Panel Light") to specify the amount of non-operation
time (in seconds) until lights turn off, or you can specify that
lights should remain lit (initial default). For information about
FUNCTION parameters, see
(FUNCTION
Mode)" (page EN-53).
• To turn the touch button lights back on, touch the 3 Mode
selector button.
• Turning on the Digital Piano under battery power only
(without AC adaptor power) will cause the Panel Light
Setting to change automatically to 60 seconds to conserve
power. You can change the Panel Light Setting if you want.
• Turning off the Digital Piano, connecting the AC adaptor,
and turning power back on will automatically cause "Off" to
be selected for the Panel Light Setting (if Auto Resume is
disabled).
FUNCTION Mode Menu
Operations
You can use the FUNCTION Mode menu to perform a wide
range of Digital Piano setting operations. The example below
explains how the selection of setting menu items (parameters)
is presented in this manual.
Example:
1.
Hold down the bp^ button until "[FUNCTION]"
appears on the display.
This enters the FUNCTION Mode.
[
F U N C T I O N
<
S OU N D
"Configuring Function Settings
]
>
Operations Common to All Modes
2.
Use the bk U and bl I buttons to select the
following menu items in sequence:
"KEYBOARD" 3 "Touch Response".
[
F U N C T I O N
T o u c h R e s
–
N o r m a l
The actual operations performed in step 2 are those below.
2-1.
Use the bk U and bl I buttons to display
"KEYBOARD" and then touch bm ENTER.
2-2.
Use the bk U and bl I buttons to display
"Touch Response" and then touch
bm ENTER.
For details about the FUNCTION Menu configuration and
operations, see
"Configuring Function Settings (FUNCTION
Mode)" (page EN-53).
• You can exit the FUNCTION Mode at any time by holding
down bp EXIT until "[FUNCTION]" disappears from the
display.
Text Character Input
Use the procedure below when you need to change the name
of data saved on a USB flash drive or to input other text.
■ To change a character
1.
Use the bk U and bl I buttons to move the
cursor to the position of the character you
want to change, and then touch bm ENTER.
This enters the character editing mode.
2.
Use the bk – and bl + buttons, or cm (K1)
knob to change the currently selected
character.
3.
To apply your edit, touch bm ENTER.
This exits the character editing mode.
]
o n s e
p
+
EN-13
Advertisement
Table of Contents
