Table of Contents
Advertisement
Digital Piano Operations
5.
Touch one of the buttons from br Area 1
through ck Area 4 to select the area where the
setup you want to recall is located.
This recalls the setup.
[
R E G I S T R A T I O N
B a n k : 0 2
A R E A 1
• This causes the Digital Piano's settings to change in
accordance with the setup you recalled.
■ Freeze Function
Recalling a registered setup normally overwrites all of the
settings shown under
"Registration Memory
EN-40). You can also use the freeze function to specify
particular settings that should not be overwritten when a setup
registration is recalled.
For FUNCTION parameter numbers
included in
57
"FREEZE") select either "On" (maintain current
setting) or "Off" (overwrite current setting) to specify what
should happen when a setup is recalled.
• For information about what settings are maintained when
"On" is selected for a FUNCTION parameter number, see
"Registration Memory
Data" (page EN-40).
• For information about FUNCTION parameters, see
"Configuring Function Settings (FUNCTION
EN-53).
EN-42
]
Data" (page
58
to
69
(parameters
Mode)" (page
Using a Pedal to Cycle Through Multiple
Setups (Sequential Pedal Recall)
You can configure Digital Piano settings so each press of a
pedal scrolls through and selects setups you registered with
the registration function.
■ To specify the pedal for recalling setups
1.
Hold down the bp^ button until "[FUNCTION]"
appears on the display.
This enters the FUNCTION Mode.
2.
Use the bk U and bl I buttons to select the
following menu items in sequence:
"REGISTRATION" 3 "SEQ PED RECALL".
3.
Use the bk U and bl I buttons to select a
pedal jack and then touch bm ENTER.
To select this pedal jack:
cr DAMPER PEDAL jack
dl EXPRESSION/ASSIGNABLE jack Exp/Asgn Pedal
4.
Use the bk – and bl + buttons to change the
pedal jack setting.
To do this:
Enable pedal recall so setups scroll
forward
Enable pedal recall so setups scroll
back
Disable pedal recall
• For information about pedal operations that can be
performed while each setting is selected, see
using the sequential pedal recall
EN-43).
• Specifying "Inc" or "Dec" for a jack will cause the pedal
connected to it to function as a registration setup recall
pedal only. Any functions assigned to the jack by
"Damper Target" (page EN-7) or "Exp/Asgn Target"
(page EN-9) will be disabled for that jack.
5.
To exit the FUNCTION mode, hold down
bp EXIT until "[FUNCTION]" disappears from
the display.
Display this:
Damper Pedal
Display this:
Inc
Dec
Off
"To play
function" (page
Advertisement
Table of Contents
