To Memorize The Transmitters From The Receiver; Possibility To Memorize The Transmitter In Three Ways; Mode 1: Single Push-Button - Teleco TVLink RS868 Instructions Manual

5.0- To memorize the transmitters from the receiver

Transmitters
The transmitters are encoded in the factory and each transmitter has its own unique code.
Caution! If you keep a channel button pressed down for more than 30 seconds the transmitter will
automatically turn off.
The receiver is compatible with all transmitters of the TVLink range: TVTXV, TVTXP, TVTXE, TVTXC,
TVTXI, TVTXK, TVTXQ, TVTXL, TVTXS.
The transmitter code can be inserted (memorized) or deleted directly in the receiver or via radio from
the transmitter. This last possibility allows to insert new transmitters into an existing installation, with-
out acting directly on the receiver. This may be carried out easily by the end user without the help of
the installer, and guaranteeing the total secrecy of the code.
- The codes transmission type is "Rolling- code". The code is changed for every transmission through
the use of an algorithm that only the receiver is able to recognize and therefore to decide if the trans-
mitted code corresponds to the original code.
- In the receiver the user code is memorized under Eeprom, which maintains the code information
even when faced with blackouts (max. 42 code-memorizations).
It is adjustable to delete the whole memory before each installation.
Errors during the memorizing
If the code is not memorized it could be due to the following conditions:
-The code already exists in memory
-The memory is full (max. 42 codes). In this case the Buzzer will make 3 beeps both during the
memorization phase both after the reset of the receiver.
Transmitter
le behaviour
according to
battery status:

5.1- Possibility to memorize the transmitter in three ways:

1 - Mode 1: Single channels with dynamic function, open, stop, close
2 - Mode 2: Control from two channels ch1 with ch2, ch3 with ch4 and ch5 with ch6 and ch7.
Ch1, ch3, ch5 for opening controls, ch2, ch4 and ch7 for closing controls, ch6 stop.
3- Mode 3: the memorised channel operates on the courtesy light in on/off mode.

5.1.1- Mode 1: single push-button

The memorization of the channels is carried out in single mode for each channel;
the memorised channel will activate the controls in dynamic mode open, stop, close.
Press and hold the push button P1,
the buzzer B1 will make 1 beep and
sound continuously.
Beep ... Beeeeeep
Battery OK
Transmit the channel which is to be
memorized, the buzzer B1 will sound
intermittently.
4
LOW Battery
Beep Beep Beep Beep
CHANGE the
Battery
open,
stop,
close