Courtesy Light Operation Mode As The Ambient Light Or Alarm; Courtesy Light Function As Alarm - Teleco TVLink RS868 Instructions Manual

7.0- Courtesy light operation mode as the ambient light or alarm

This procedure can be done within 30 seconds after the reset.
1- Press for 5 sec. the push
button P3 of the transmitter;
the buzzer will sound 1 beep,
press and
hold for 5 sec.
P3
On
240V
Beeep

7.1- Courtesy light function as alarm

It is possible to use the output of the courtesy light, to interface the control unit to an alarm system,
memorizing a radio alarm transmitter (code: TVSSH or TVTCTM) with mode 3 memorization and acti-
vating the "courtesy light as alarm" function (see 7.1 ).
If the control unit receives an alarm signal from the radio alarm transmitter, the courtesy light output is
activated for 1 minute.
Warning: the courtesy light output provides 240Vac. The interface of the alarm system must be ar-
ranged according to the specifications of the installed alarm system.
release and re-press within 5 sec. the
push button P3 of the transmitter 3
times, the buzzer will sound 1 beep
at each pressure and at the end it will
press 3 times
5 sec.
Beep
P3
wait 5 sec.
1 2 3
Alarm
interface
10
sound:
3 beeps to indicate ambient
light mode and
5 beeps to indicate alarm
function.
3 Beeps: ambient light
5 Beeps: alarm function
Alarm
system