Advertisement
Quick Links
READ ME FIRST:
Thank you for purchasing a Front Runner Slimline II Rack.
This Roof Rack consists of a kit that contains:
1.) A Slimline II Tray
2.) A mounting system specific to your vehicle
This document will help you fit the Slimeline II Tray to your specific vehicle.
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR
VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY IN-
JURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER
PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PROD-
UCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS
AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDER-
STAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOR-
OUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSION-
AL INSTALLER OR OTHER QUALIFIED PERSONNEL.
FATL002 / KRTL029T_REV_A02
Toyota LAND Cruiser 100
SLIMLINE II RACK
( 1345MM X 1964mm )
IMPORTANT WARNING!
1
FATL002 / KRTL029T
INSTALL TIME: 1 Hour
Advertisement
Related Manuals for Front Runner Toyota LAND Cruiser 100 SLIMLINE II
Summary of Contents for Front Runner Toyota LAND Cruiser 100 SLIMLINE II
- Page 1 VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY IN- JURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PROD- UCTS FOR ADJUSTMENT, WEAR, AND DAMAGE.
- Page 2 GET ORGANIZED... Here is what you are looking at: Please note that only the right hand side's components and fitment has been shown. Item # Quantity Description You will need: M8 NUT CAP 13 mm Flat and Socket Wrench M8 x 40 HEX BOLT 12 mm Flat or Socket Wrench M8 SPRING WASHER 10 mm Flat and Socket Wrench...
- Page 3 Fit the foot rails Loosely join the Front and Rear Foot Rails (Items 7 & 8) together using the M6 x 16 Button Head Bolts, M6 Flat Washers, M6 Nyloc Nuts and Joiner Plates (Items 9, 10, 11, 12). Tighten all the Nuts and Bolts and place a M6 Nut Cap (Item 13) over each Nyloc Nut.
- Page 4 Fit the foot rails Cont... Place the assembled Foot Rails onto the vehicle's roof, lining up the mounting holes in the bottom of the Foot Rails with the mounting points on the vehicle. Depending on the vehicle specifications, you will ei- ther use mounting point number 1 or 2 as indicated by the arrows for the front of the vehicle.
- Page 5 You'll find a small amount of settling has happened. Go on many more adventures, periodically checking all nuts, bolts, screws and fittings. Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle manufacturer's recommendations.