Advertisement
Fit the foot rails
(
)
Loosely join the Front and Rear Foot Rails (Items 7 & 8) together using the M6 x 16 Button Head Bolts, M6
A
Flat Washers, M6 Nyloc Nuts and Joiner Plates (Items 9, 10, 11, 12). Tighten all the Nuts and Bolts and
place a M6 Nut Cap (Item 13) over each Nyloc Nut.
(
)
Locate and remove the six Plastic Covers (three each
B
side) in the Ditch Moulding of the vehicle's roof. This
is done my pushing the covers towards the front or
rear of the vehicle and lifting.
( C )
Remove the bolts and steel bracket below each Plastic Cover removed in Step 2B. The front and rear
brackets are secured with two bolts and the center brackets a secured using three bolts.
(
)
Clean the area around the threaded holes in the vehicle's roof using a rag and some methylated spirits /
D
denatured alcohol. Place some silicone around each threaded hole in the vehicle's roof and the cut-outs
in each of the Spacers (Item 14 & 15 ) as shown. Position the Spacers into the vehicle's gutters (silicone
side down, lining up the cut-outs in the Spacers with the threaded holes in the vehicle roof.
FATL002 / KRTL029T_REV_A02
Silicone
3
Advertisement
