Front Runner LASJ003 Manual

Suzuki jimny 2018-current ladder

Download this manual

ENG

front runner

SUZUKI JIMNY (2018-CURRENT) LADDER

LASJ003

READ ME !

Thank you for purchasing a Front Runner Suzuki Jimny (2018 - Current) Ladder.

Before you start, take a moment to familiarize yourself with the Fitting Instructions and the included components.

Refer to Page 2 for a list of all the components, quantities and tools required.

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD

RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT

RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND

DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO

INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY

FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.

Please call us if you have any questions about the installation of this product.

LASJ003_REV_A00

Page 1 FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL. NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Page 2: Tools Needed
12mm M8 x 20 Button Head Bolt M8 x 16 x 1.6 Flat Washer 10mm Masking M8 Nyloc Nut Marker 13mm Tape 16 X M6 Nut Cap Denatured Alcohol Torque Wrench FIGURE 1.1 LASJ003_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 3 Note Orientation: Tightening Torque 8-10Nm / 5.9 ft lb - 7.38 ft lb. Take care when using a cordless driver. Place M6 Nut Caps (Item 15) over all M6 Nyloc Nuts (Item 11). LASJ003_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 4 2.5 and press the bracket up against the door so the door sits in the slot (B). Mark the hole centers (C) as shown. Drill a 4mm Pilot hole and open up to 12mm. 12mm LASJ003_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 5 Head Bolts, M8x 16 x 1.6 Flat Washers and M8 Nyloc Nuts (Items 12, 13 & 14) as shown. Tightening Torque: 13mm M8 : 15-20Nm / 11.06 ft lb - 14.75 ft lb LASJ003_REV_A00 © 2022 FRONT RUNNER VEHICLE OUTFITTERS...
Page 6 Congratulations! You did it. Take a step back and admire your work! INSTALL OTHER VEHICLE AND RACK ACCESSORIES Now's the time to visit your favorite Front Runner Dealer in person or online. Be sure to tag us. We love to see our gear in action! #FrontRunnerOutﬁtters #BornToRoam...