Ei Electronics Ei207 Series Instructions For Use Manual page 43

Immediately release the button. This Alarm will now send an RF message to all the
previously installed (compatible) devices to re-enter House Code mode. Similarly,
install and put the new Alarm you wish to add to the system into House Code mode
(see "Installation and House Coding" section). As before, allow sufficient time so
that all Alarms are now house coded correctly (this can be confirmed by counting
the number of flashes on each Alarm). You can then exit House Code mode
manually or let it exit automatically after 30 minutes. (N.B. for this feature to work
all devices in the system must be RadioLINK+).
2. Monitoring
The Ei200MRF RadioLINK+ Module has the ability to "Monitor" the RF signal path
and strength. This is an enhanced self-monitoring function that recognises system
tampering or Alarm head removal. In monitoring mode each Alarm will check the
presence of its strongest received RF signal. If the signal is missing then the Alarm
will record a monitoring failure event. It will also signal the failure via a change in
the indicator light pattern.
For more information on using this feature, please visit www.eielectronics.com and
refer to the relevant section on the RadioLINK+ Monitoring feature.
3. Data Extraction
The Ei200MRF RadioLINK+ Module allows for the extraction of information from an
Ei Electronics Compatible Alarm, using an Ei Electronics download device. Once
the system has been set up, information can be accessed securely from within
or outside a property if access is an issue The event log can contain very useful
information about any recorded events in the history of the Alarm such as: CO
Events, Alarm Head removals, Button Tests, and so on.
7