Configure The Profinet Controller Module; Figure 23: Assign Profinet Status Address; Figure 24: Disable Port Criticality (For Debug Only) - GE PACSystems RX3i Application Manual
Genius dual bus
Hide thumbs
Also See for PACSystems RX3i:
- User manual (169 pages) ,
- Command line interface manual (116 pages) ,
- Secure deployment manual (35 pages)
Table of Contents
Advertisement
5.4
Configure the PROFINET Controller Module
The PROFINET Controller Module has a 32-bit diagnostic/status reference. The recommended starting
reference is %I16465 (the next available reference following the Ethernet port status reference).
NOTE 1: For each slot in which a PROFINET Controller is installed, the Primary module and the
Secondary module will always have identical Status Addresses. (However, the PROFINET
Controllers from one slot to another will have separate, unique addresses).
NOTE 2: For the purposes of early project development/debug, it may be simpler to disable the
port criticality parameters. However, these should be enabled before the project is
installed in an operating environment.
GFK-2928
Figure 23: Assign PROFINET Status Address
Figure 24: Disable Port Criticality (for Debug only)
December 2017
Chapter 5. PLC Hardware Configuration (Primary PLC)
25
Hide quick links:
Advertisement
Table of Contents
