Table of Contents
Advertisement
Table 9 Acceptance Logs Available (Continued)
Screen
Language Function
To change a Language from English to another
Language, proceed as follows:
1. Turn the DT-300™ Power Switch ON, and the
SD Card check will begin (See Figure 45).
Figure 45 SD Card Confirmation Screen 8
2. Select "
LANGUAGE
Screen and press the
desired Language from the list available
(See Figure 46).
Figure 46 Function Selection Screen 8
3. Select the preferred language; English or Deutsch
(German) as shown in Figure 47 in this example.
Figure 47 Language Selection Screen
Operation Procedures
(Bootloader)
This portion provides each Bootloader procedure of
the DT-300™ Device operation.
DT-300 F
U
IRMWARE
To update the Firmware of the DT-300™, proceed
as follows:
1. Ensure that the SD Card contains the latest Ver-
sion of Firmware (Refer to "Firmware File" on
page 13 of this Guide for details regarding the
proper Firmware File selection).
P/N 960-000167R_Rev. 1 {EDP #214645}
DT-300™ Series Download Tool Operator Integration Guide
Description
Total Ticket
Acceptance Rate
Limited Number of the
Banknote
Acceptance Rate 1
Limited Number of the
Banknote
Acceptance Rate 2
" from the Function Selection
Key
to select the
OK
PDATE
NOTE: The Firmware File should be
newer than the current Firmware Version
presently in the DT-300.
2. Turn the DT-300™ Power Switch ON while
pressing the
Key
UP
Key
. The Firmware Update Confirmation
Screen shown in Figure 48 will appear.
Figure 48 Firmware Update Confirmation Screen
3. Press the
Key
OK
Firmware update. The LCD Screen will display a
Progress Bar during the Firmware updating pro-
cess as shown in Figure 49.
Figure 49 Firmware Update Progress Bar
4. Once the update is complete, the LCD Screen will
display the new "
Message (See Figure 50).
Figure 50 Firmware Update Success Screen
DT-300 EEPROM U
To update the EEPROM Data in the DT-300™
Device, proceed as follows:
1. Ensure that the SD Card contains the EEPROM
Data (Refer to "EEPROM Data File" on page 13
of this Guide for details regarding the EEPROM
Data File).
2. Turn the DT-300™ Power Switch ON while
pressing the
LEFT
The EEPROM Update Confirmation Screen
shown in Figure 51 will appear.
Figure 51 EEPROM Update Confirmation Screen
3. Press the
Key
OK
update. The LCD Screen will display a Progress
Bar during the EEPROM updating process as
shown in Figure 52.
© 2013, Japan CashMachine Co., Limited
1 1
and the
DOWN
to begin the DT-300™
Bootloader X.XX Succeeded.
PDATE
Key
or the
Key .
RIGHT
to begin the EEPROM
"
Hide quick links:
Advertisement
Table of Contents
