Installation; Battery Installation; Sd Card Installation; Installation To Apc Or A Card Reader - JCM GLOBAL DT-300 Series Operator Integration Manual

6 INSTALLATION

Battery Installation

Perform the following steps to install Batteries into
the DT-300™ Device:
1. Push the two (2) Tabs of the Battery Cover in the
direction of the Arrow illustrated in Figure
lift the Cover off of the Device.
2. Install four (4) AAA Batteries into their correct
polarized position in the direction illustrated in
Figure 4.
3. Place the Battery Cover back into its original
position, and listen for it to "Click" back into
place.
a
Figure 4 Type AAA Battery Installation

SD Card Installation

I PC
NSTALLATION TO A
Perform the following steps to install the SD Card
into a PC or an SD Card Reader:
NOTE: When creating the storage Folder for
each Model, use the SD Card Slot of a PC or an
SD Card Reader.
1. Insert the SD Card into an SD Card Reader, or an
SD Card Reader Slot of the PC.
SD Card
Slot
SD Card
Figure 5 SD Card Insertion (PC or Card Reader)
2. Create each model Folder in the first layer of the
SD Card. Each Folder Name needs to include a
"space" before the word "System".
P/N 960-000167R_Rev. 1 {EDP #214645}
DT-300™ Series Download Tool Operator Integration Guide
4a and
+
Tabs
+
C R
OR A ARD EADER
SD Card
Reader
SD Card
Figure 6 Model Name Creation
NOTE: Up to twenty (20) Folders can be
created on an SD Card.
Figure 7 Model Folder Creation
NOTE: Refer to "Compatibility" on
page 14 for the details regarding each
Model's setting.
3. Save the Software Data Files (xxxxxxxxx.COM)
for each Model's Folder. Refer to the "Software
Data File" on page 13 of this Guide for more
details.
NOTE: Do NOT erase the
"BWDXCARD.INF" Card Information File!
If the Card Information is lost, Card
Reading errors may occur.
NOTE: When removing the SD Card,
follow the User Guide of the PC, or the
SD Card Reader.
SD C I
ARD NSTALLATION
Perform the following steps to install/remove the
SD Card into/from a DT-300™ Device:
1. Ensure the DT-300™ Power is OFF.
2. Slide the SD Card into the Unit in the direction
indicated by the Red Arrow shown in Figure 8
until it "clicks" in place.
SD Card Slot
SD Card
Figure 8 SD Card Insertion (DT-300)
© 2013, Japan CashMachine Co., Limited
5
Space
I DT-300
NTO A