Error Message Function; Version Check Function; Maintenance Function; Figure 36 Function Selection Screen 6 - JCM GLOBAL DT-300 Series Operator Integration Manual

Error Message Function

To receive/display the error condition from the 
Validator, proceed as follows:
1. Turn the DT-300™ Power Switch ON, and the
SD Card check will begin (See Figure 27).
Figure 27 SD Card Confirmation Screen 4
2. Select the "
ERROR MESSAGE
tion Selection Screen and press the
select it (See Figure 28).
Figure 28 Function Selection Screen 4
3. Make sure that the LCD displays the Standby
Screen shown in Figure 29.
Figure 29 Standby Screen 2
4. Press the Key
OK
Code Indication Screen shown in Figure 30. Press
the Key
CLR
tion Selection Screen.
Figure 30 Active Error Code Indication Screen
5. Confirm the Active Error Code. Press the
Key or the
CLR
ous Standby Screen.

Version Check Function

To obtain the Version, CRC and Serial Number
from the Validator, proceed as follows:
1. Turn the DT-300™ Power Switch ON, and the
SD Card check will begin (See Figure 31).
Figure 31 SD Card Confirmation Screen 5
2. Select "
VERSION CHECK
Selection Screen and press the
select it (See Figure 32).
P/N 960-000167R_Rev. 1 {EDP #214645}
DT-300™ Series Download Tool Operator Integration Guide
" from the Func-
Key
OK
to display the Active Error
to return to the previous Func-
OK
Key to return to the previ-
" from the Function
Key to
OK
Figure 32 Function Selection Screen 5
3. Ensure that the LCD displays the Standby Screen
shown in Figure 33.
to
Figure 33 Standby Screen 3
4. Press the Key
OK
CRC and Serial Number Indication Screen
(See Figure 34). Press the
to the previous Function Selection Screen.
Figure 34 Version, CRC & Serial Number Screen
5. Confirm the Version, CRC and Serial Number.
Press the Key
OK
return to the previous Standby Screen.

Maintenance Function

To review/display the Maintenance Condition
information of the Validator, proceed as follows:
1. Turn the DT-300™ Power Switch ON, and the
SD Card check will begin (See Figure 35).
Figure 35 SD Card Confirmation Screen 6
2. Select "
MAINTENANCE
Selection Screen and press the
select it (See Figure 36).

Figure 36 Function Selection Screen 6

3. Ensure that the LCD displays the Standby Screen
(See Figure 37).

Figure 37 Standby Screen 4

© 2013, Japan CashMachine Co., Limited
9
to display the Version,
Key to return
CLR
or the Key to
CLR
" from the Function
Key to
OK