BONFIGLIOLI Vectron Agile Communications Manual page 44

 412 Local/Remote
The frequency inverter can be controlled with various operation modes. These operation modes can
be selected with parameter
Local/Remote
0 - Control via Contacts
Control via
1 -
Statemachine
Control via Remote
2 -
Contacts
For operation via the serial interface, settings 0, 1 and 2 are relevant. Further possible operation
Local/Remote
modes
to the control via the Operator Panel and the control via digital signals.
Local/Remote
Parameter
between the different operation modes.
 414 Data Set Selection
The data set switch-over can be carried out via control contacts at the digital inputs of the frequency
inverter or via the bus. For data set change-over via the bus, parameter
used.
Parameter
No. Name
414 Data Set Selection
With the default setting
digital inputs.
Data Set Selection
If
same time, data set change-over via the digital inputs is deactivated.
Data Set selection
If
inverter is not released.
The currently selected data set can be read out with Parameter
249 states the activated data set with the value 1, 2, 3 or 4. This is independent of whether the data
set change-over was carried out via control inputs or via
8
Statemachine is a standardized software module within the controller of the frequency inverter. The State-
machine represents the specified operating states and control within the frequency inverter.
44
Local/Remote
412.
412
The Start and Stop commands as well as the direction of rotation are
set via digital signals.
The Start and Stop commands as well as the direction of rotation are
controlled via the Remote Statemachine
face.
The Start and Stop commands as well as the direction of rotation are
controlled via virtual digital signals through the communication proto-
col.
412 are described in the frequency inverter operating instructions. These relate
412 is data set related, i.e. by selecting a data set, you can switch over
Data Set Selection
414 is set to 1, 2, 3 or 4, the selected data set is activated via the bus. At the
414 = 5, then data set switching is only carried out whenever the frequency
Function
Setting
Min. Max.
0 5
414 = 0, the data set change-over is carried out via the
Active Data Set
Data Set Selection
VABus Agile
Control / Reference Value
8
of the communication inter-
Data Set Selection
Factory Setting
0
Active data set
249.
414.
414 is
06/2010