Vabus On The Optional Communication Module - BONFIGLIOLI Vectron Agile Communications Manual

VABus
 1501 X21: VABus Node-ID
X21: VABus Node-ID
With Parameter
set. The setting applies to the X21-Connection. Parameter
- CM: VABus / X21: VABus" or "2 - CM: Modbus / X21: VABus".
Parameter
No. Description
1501 VABus-X21 Node-ID
 1502 X21: VABus Watchdog Timer
The communication can be monitored. If the communication fails, then no data or incorrect data will
be transferred. This state will be detected by the Communication Watchdog.
The Watchdog-Function monitors the time within which no correct communication occurs. This time
can be set with Parameter
within which at least one correct data exchange must occur.
If the set monitoring time is reached the frequency inverter generates the error F2010.
The setting applies to the X21-Connection. Parameter
"0 - CM: VABus / X21: VABus" or "2 - CM: Modbus / X21: VABus".
Parameter
No.
1502 VABus-X21 Watchdog Timer
If the parameter is set to zero (factory setting), then monitoring is switched off.
6.2

VABus on the optional Communication Module

 10 CM: VABus Baud Rate
CM: VABus Baud Rate
With Parameter
The setting applies to the slot for an optional Communication Module. Parameter
395 must be set to "0 - CM: VABus / X21: VABus" or "1 - CM: VABus / X21: Modbus".
CM: VABus Baud Rate
1 –
2 –
3 –
4 –
5 –
6 – 115200 Baud
7 – 230400 Baud
CM: VABus Baud Rate
Parameter
Caution!
Changes to the baud rate are effective immediately. A restart of the frequency inverter is not re-
quired.
All bus participants must be set to the same baud rate.
06/2010
1501 the node address for the VABus communication can be
X21: VABus Watchdog Timer
Description
10 the transfer rate of the VABus communication can be set.
10
2400 Baud Transfer rate 2400 Baud
4800 Baud Transfer rate 4800 Baud
9600 Baud Transfer rate 9600 Baud
19200 Baud Transfer rate 19200 Baud
57600 Baud Transfer rate 57600 Baud
Transfer rate 115200 Baud
Transfer rate 230400 Baud
10 is only available if a communication module is installed.
Protocol (CM / X21)
Setting
Min. Max.
1 30
1502. The set value is the time in seconds
Protocol (CM / X21)
Setting
Min. Max.
0 s 10000 s
Function
VABus Agile
395 must be set to"0
Factory Setting
1
395 must be set to
Factory Setting
0 s
Protocol (CM / X21)
max. Line Length
30 m
30 m
30 m
30 m
10 m
10 m
10 m
23