BONFIGLIOLI Vectron Agile Communications Manual page 24

 394 CM: VABus NodeID
CM: VABus NodeID
With Parameter
The setting applies to the slot for an optional Communication Module. Parameter
X21)
395 must be set to "0 – VABus / VABus" or "1 – VABus / Modbus".
Parameter
No. Description
394 CM: VABus NodeID
CM: Communication Module
CM: VABus NodeID
Parameter
 413 CM: VABus Watchdog Timer
The communication can be monitored. If the communication fails, then no data or incorrect data will
be transferred. This state will be detected by the Communication Watchdog.
The Watchdog-Function monitors the time, within which no correct communication occurs. This time
can be set with Parameter
within which at least one correct data exchange must occur.
If the set monitoring time is reached the frequency inverter generates the error F2011.
The setting applies to the slot for an optional Communication Module. Parameter
395 must be set to "0 - VABus/VABus" or "1 - VABus/Modbus".
Parameter
No.
413 CM: VABus Watchdog Timer
CM: Communication Module
If the parameter is set to zero (factory setting), then monitoring is switched off.
CM: VABus Watchdog Timer
Parameter
24
394 the node address for the VABus communication can be set.
394 is only available, if a communication module is installed.
CM: VABus Watchdog Timer
Description
413 is only available if a Communication Module is installed.
Setting
Min. Max. Factory Setting
1 30
413. The set value is the time in seconds
Setting
Min. Max.
0 s 10000 s
VABus Agile
VABus
Protocol (CM /
1
Protocol (CM/X21)
Factory Setting
0 s
06/2010