Checklist To Be Made By The Installer Before Calling Carrier Service Commissioning Unit - Carrier AquaForce PUREtec 30XAV-ZE 401 Installation, Operation And Maintenance Instructions

Variable-speed air-cooled screw chillers with r1234ze (e)
Table of Contents

Advertisement

12 - CheCKlIsT TO Be MaDe By The INsTalleR BefORe CallINg CaRRIeR seRVICe COMMIssIONINg
UnIT
Preliminary information
Job name: ..............................................................................................................................................................................................
Location: ................................................................................................................................................................................................
Installing contractor: ............................................................................................................................................................................
Distributor: ...........................................................................................................................................................................................
equipement
Model 30XAV-ZE: ................................................................................................................................................................................
Compressors
Circuit A
Model #
S/N
Motor #
Inverter compressor frequency
Model # (circuit A/B) :
Serial number (circuit A/B) :
evaporator
Model : ...................................................................................................................................................................................................
S/N ..........................................................................................................................................................................................................
Condensing module
Model # : ................................................................................................................................................................................................
Unit options and additional accessories
.................................................................................................................................................................................................................
.................................................................................................................................................................................................................
Is there any shipping damage ..............................................................................................................................................................
If so, where? ...........................................................................................................................................................................................
Will this damage prevent unit start-up? .............................................................................................................................................
Unit is level in its installation
Power supply agrees with the unit name plate
Electrical circuit wiring has been sized and installed properly
Unit ground wire has been connected
Electrical circuit protection has been sized and installed properly
All terminals are tight
All cables and thermistors have been inspected for crossed wires
Chilled water pipes are properly connected
All plug assemblies are tight
The chilled water pump operating with the correct rotation. Check the phase sequence of the electrical connection.
In the case of a unit with hydronic module, use the pump test function (refer to manual control 30XAV-ZE for a
more detailed explanation).
The machine is reset once power off the pump test performed.
Circulating ice water in the hydraulic circuit for at least 2 hours, then remove, clean and replace the strainer. The
machine is reset once power off the pump test performed.
Piping water inlet to the evaporator includes a strainer with a mesh size of 1.2 mm (20 mesh)
Circuit B
Model #
S/N
Motor #
Fan Inverter frequency
Model # (circuit A/B) :
Serial number (circuit A/B) :
39

Advertisement

Table of Contents
loading

Table of Contents