How To Mount The Pcb Control - Elma Elmasonic S Series Service Manual

8.1.3
How to proceed
© Elma Schmidbauer GmbH
A
Illustration 8.2. Bend the two clips upwards ...
Abb. 8.3. ... and tilt the PCB control to the inside

How to mount the PCB control

1. Connect the electric plug connections (see illustrations 8.1.
and 8.4.). Note: All plug connections are coded and cannot
be interchanged when mounted.
2. Place the PCB control into the groove of the lower fixation of
the PCB support (illustration 8.3.A.). The horizontal
adjustment of the component depends on the lighted diodes
on the PCB control and the recesses in the PCB support
and the potentiometers.
3. Clip the correctly positioned PCB control into the upper
fastening clips (see illustration 8.2. / 8.3.).
4. Mount the turning knobs as described in section 7.2.
5. Close the bottom plate as described in section 6.4.
SM_Elmasonic_S_02.2018_EN
How to replace the PCB control
A
A
29