Yamaha VMX12 2001 Service Manual page 221

TRANSMISSION
5. Install:
• bearing stoppers 1
NOTE:
@
Insert the bearing stoppers completely into the
grooves in the lower crankcase.
@
6. Lubricate:
• oil seal lips
(with a thin coat of the recommended lubri-
cant)
Recommended lubricant
Lithium soap base grease
7. Install:
• push rod bearing 1
• oil seal 2
WARNING
@
Always use a new O-ring.
@
NOTE:
@
• Insert the bearing pin into the hole in the
crankcase.
• Position the oil seal against the push rod
bearing.
@
8. Install:
• main axle assembly 1
• drive axle assembly 2
WARNING
@
Always use new circlips.
@
NOTE:
@
Position the bearing pins 3 as shown.
@
9. Check:
• transmission
Rough movement → Repair.
NOTE:
@
Oil each gear, shaft, and bearing thoroughly.
@
4 - 91
ENG